Tabla de contenido
Publicidad
R&S HZ-9
Fig. 4 Position of the cable W1
If the power supply's output voltage deviates from the values specified in the data
sheet, proceed as follows.
It is advisable to first check the power supply for defects in an unloaded state and
correct any problems that might occur. Then, repeat the test with a load connected.
Here, the DC output should not exceed 100 mA per output.
Danger of shock hazard
For measurements in circuits with voltages V (RMS) > 30 V, suitable measures (e.g.
appropriate measuring equipment, fusing, current limiting, electrical separation,
insulation) should be taken to avoid any hazards.
Manual 1316.4969.02 - 01
Service
7
Publicidad
Tabla de contenido
