Glass 1989 SAUNE Manual De Uso página 45

The light turns off automatically when the
sauna is turned off via the
button.
MENU/OK BUTTON
By pressing the button "MENU/OK" you
will be able to see the temperature and
session duration on the display, both
signalled by the relevant LED light. The
display will show the current setting for the
selected function. This button is also used
Sequence of the various options that can
be selected with the "MENU/OK" button:
Temperature radiant area 1 + 2
Temperature radiant area 1
Temperature radiant area 2
Session duration
Fan
BUTTON
By pressing the button
value of the selected option. By keeping
the button pressed the value goes up
faster. As soon as the button is pressed,
value set is displayed.
BUTTON
By pressing the button
selected option decreases. By keeping
the button pressed, the value goes down
quicker. As soon as the button is pressed,
value set is displayed.
DISPLAY: Indicator of temperature
and duration of session
The number lit up with a constant light on
the display determines the current setting
(relative to the temperature or session
duration) inside the sauna. To set new
values to the sauna, use the buttons
or
OK" or until the setting is automatically set
after 5 seconds.
TEMPERATURE RADIANT AREA 1
(ON/OFF)
To set the desired temperature in radiant
area 1, set it via the button "MENU/OK"
on the corresponding LED "1".
Then set the desired value via the buttons
setting press the button "MENU/OK" or
else wait until the value is automatically
set after 5 seconds.
TEMPERATURE RADIANT AREA 2
To set the desired temperature in radiant
area 2, set it via the button "MENU/OK"
on the corresponding LED "2".
Then set the desired value via the buttons
setting press the button "MENU/OK" or
else wait until the value is automatically
set after 5 seconds.
you increase the SESSION DURATION
To set the desired session length, set
it via the button "MENU/OK" on the
corresponding LED
desired value via the buttons
(99 minutes max), the numbers on the
press the button "MENU/OK" or else wait
the value of the
until the value is automatically set after 5
seconds.
FAN
(not supplied with the sauna)
If there is a fan installed in the sauna, it
can be connected to the control unit and
controlled by the command mentioned
above.
To activate the fan, set it via the button
"MENU/OK" on the corresponding LED
. Then activate the function via the button
pressing the button
the setting press the button "MENU/OK"
or else wait until the value is automatically
"MENU/
set after 5 seconds.
13
and (max 50°C), the numbers on the
and (max 50°C), the numbers on the
(ON). Do the same to turn it off by
EN
.Then set the
and