Axis Q87-E Serie Guia De Instalacion página 15

AXIS Q87-E Installation Guide
4. Attach the top cover to the bottom cover. Make sure to tighten diagonally opposite bottom cover screws a few
turns at a time until all are tight (torque 4 Nm). This will help ensure that the bottom cover gasket is
compressed evenly.
5. Attach the sunshield to the top cover.
6. Loosen the counterweight locking screws and adjust the position of the weights to the desired position. The
positions of the weights must be identical.
Note:The pan/tilt assembly must remain balanced for the pan/tilt function to operate correctly. Check the
balance by swinging the housing slightly.
7. Remove the protective plastic from the protective window.
11
10
1 Sunshield
2 Washer (4x)
3 Lock washer (4x)
4 Sunshield screw (4x)
5 Top cover
6 Bottom cover
1
2
3
4
5
6
7
8
9
7 Bottom cover screw (10x)
8 Counterweight
9 Counterweight locking screws
10 Positioning holes
11 Protective plastic
Page 15