Klein Tools KTB5 Manual Del Usuario página 5

KTB5 WILL NOT CHARGE OR OPERATE CONNECTED DEVICES:
• Ensure that the output ports ,
6
• Confirm the connected device is suitable for the KTB5 by reviewing the output specifications provided in the GENERAL SPECIFICATIONS section.
• Confirm the battery is charged by reviewing the charge level
• Verify whether a warning icon
E
KTB5 WILL NOT CHARGE:
• Verify that the AC Charger Input
• Confirm that the charger's cord is inserted fully into the AC Charger Input.
• Confirm that the AC Wall Charger
• If the input does not comply with the requirements located in the GENERAL SPECIFICATIONS section, the Low Input Voltage icon
NOTE: The LCD display will provide additional fault codes that can be reviewed in the FEATURE DETAILS section.
2
Be sure that KTB5 is disconnected from all input power sources and output devices. Use a clean, dry, soft-lint-free cloth to wipe down the unit. Remove any debris,
dirt, or other blockages on both side vents. When cleaning debris from the side vents, do not allow the debris, dirt, or other blockages to enter the body of KTB5.
Do not use abrasive cleaners or solvents.
Do not use use compressed air to clean side cooling vents,as this will force foreign particles into the internal circuitry.
To avoid the risk of electrical shock, DO NOT use metal objects to clean ports.
Recharge as needed. There are no pre-designated intervals at which to recharge as long as the KTB5 is being used regularly. Avoid discharging completed on a
regular basis, as this can impact overall life.
Regularly inspect all ports and wall charger for any debris, dirt, damage and corrosion. DO NOT attempt to fix.
Regularly observe if the side vents are collecting dirt or dust, and clean following cleaning procedures noted in manual.
If storing for more than 1 month, charge completely before storage and recharge approximately every 3 months to avoid full discharge and possible damage.
Store indoors, in cool temperatures, mild humidity, and away from direct sunlight (See GENERAL SPECIFICATIONS section). Leaving in a vehicle or other confined spaces in
extreme hot temperatures can lead to decreased service life, overheating, and fire. Extreme cold conditions below specific storage range can also harm performance and service
life.
Keep away from corrosion chemicals and gases
After taking out of storage, visually inspect to make sure KTB5 and all accessories look satisfactory. This increase review the intake and exhaust side vents to ensure they are clear
of debris. Allow unit to return to ambient conditions before recharging, or charging other devices.
Do not place equipment and its accessories in the trash. Items must be properly disposed of in accordance with local regulations. See www.epa.gov for additional information.
, and/or are activated by pressing the button
7 9
. This may need to be displayed by pressing the INFO
A
, , , is displayed on the LCD
F G H
is illuminated. If not, the AC charger being used may not be providing an output.
3
14 is the charger provided with KTB5.
www.kleintools.com/warranty
450 Bond Street Lincolnshire, IL 60069
TROUBLESHOOTING
and/or for the port(s) in use.
5 8
.
2
CLEANING
MAINTENANCE
STORAGE
WARRANTY
DISPOSAL / RECYCLE
CUSTOMER SERVICE
KLEIN TOOLS, INC.
1-877-553-4676
customerservice@kleintools.com
www.kleintools.com
or LIGHT button.
12 11
may be displayed on LCD screen.
H
5