Draining Tanks; Draining Solution Tank; Draining Recovery Tank; Machine Maintenance - Nobles Explorer H5 Manual Para El Operador Y De Repuestos

EN
English
CAUTION When handling wand avoid contact
with hose coupler, valve and metal solution line.
This area could create a burn hazard. Wear
protection gloves as needed.
5. Let up on the trigger about 4 inches before the end of the
stroke for maximum water recovery.
6. Push the wand forward at a slight angle until next stroke is
slightly overlapping previous stroke.
7.
moving to the next area.
NOTE: Use defoamer any time foaming occurs in the recovery
tank to prevent damage to the motor or other components.
8. Monitor the water level in the solution tank. If solution tank
runs dry, the pump must be reprimed.
9. When the solution tank is low, turn off all the switches,
10.
disconnecting solution hose relieve the water pressure from
the wand by holding the lever on the wand.
CAUTION When disconnecting solution hose coupler wear
protective gloves to avoid burn hazard.

DRAINING TANKS

DRAINING SOLUTION TANK

from the solution tank. Place the end of the vacuum hose that
was attached to the wand into the solution tank and turn the
vacuum switch on.

DRAINING RECOVERY TANK

1. Turn off all switches.
2. Drain the recovery tank by holding the end of the drain
hose with the cap above the machine. Remove the cap
on the drain hose. Lower the drain hose over a drain or a
bucket to drain the recovery tank.
8

MACHINE MAINTENANCE

To keep machine in good working condition, simply follow
machine maintenance procedures
AFTER EACH USE
1.
clean water by running the machine using clean water at
2. Drain and rinse out recovery tank.
3.
solution
4. Wipe down the machine with a damp cloth. Do not hose off
or power spray machine.
5. Inspect solution hose and vacuum hose for cracks or damage
Do not use hose if damaged.
6. Store extractor with tank covers off to promote air circulation
7. Inspect electrical cord ends on the machine and the power
cords used with the machine for damage. Replace power
service person if cord ends on machine are damaged.
8. Coil power cords neatly after each use and store on
machine.
.
FOR SAFETY When ser icing machine
unplug cords from wall outlets. Wear
appropriate personal protection
equipment as needed.
Nobles Explorer H5 (01/2014)
Be sure to
Ball Float
Screen
Solution
Tank Filter
.