Wiring The Relays - Leviton DMX Serie Guia De Instalacion

Wiring the Relays

Step 1: Connect the line (feed/circuit breaker) side of the circuit to the "input"
terminal(s) on the relay card.
Step 2: Connect the load side of the circuit to the "output" terminal(s) on the
relay card.
Step 3: Please note that relay card terminals accept the following wire sizes:
Relay Type Wire
(Part #) Size
Standard 20-8 Solid or
1-Pole relay AWG Stranded
module Copper
(RELAY-STD)
2-Pole relay 20-6 Solid or
module AWG Stranded
(RELAY-2PL) Copper
347V relay 20-6 Solid or
module AWG Stranded
(RELAY-347) Copper
Latching 20-8 Solid or
Relay Module AWG Stranded
(RELAY-LAT) Copper
NOTE: Circuit neutrals may follow the path of the line/load conductors through the
relay panel or the line/load conductors may pass back to the panel board to
be joined with the neutral to the load.
The diagrams on the following pages show how to wire the relay circuits.
WARNING: MISWIRING THE RELAY MODULES WILL CAUSE DAMAGE TO THE
RELAY MODULE, THE RELAY CABINET, AND POSSIBLY OTHER SYSTEMS
Wiring Diagram for Standard 1 Pole Relay Card
8
Wire Max
Torque
Type Voltage
7 in-lbs 277V
20.5 in-lbs 277V
per pole
(480V)
20.5 in-lbs 347V
7 in-lbs 277V
347V
Wire Sizes & Capacities for Relays
(latching relay card similar)
Tungsten
Ballast Motor Rating
Rating
Rating (120V/277V)
(120V)
20A 20A 1HP/2HP
– 20A 2HP
– 20A
20A 20A
1HP/2HP
– 15A
Load
Line (from Distribution Panel)
Inductive
Ballast,
Transformer,
HID Rating
20A
20A
– 20A
20A
15A