Removing The Cylinder - Honeywell HM700ACYL2 Instrucciones De Instalación

HM700ACYL2
CAUTION
Equipment Damage
Failure to replace the cylinder at the end of
cylinder life will result in improper operation and
may result in damage to the humidifier. Honeywell
is not responsible for any damages resulting from,
or attributed to, the failure to replace a spent
cylinder.
HIGH WATER SENSOR PIN HAS
A PLASTIC COLLAR AROUND IT.
CONNECT ORANGE HIGH WATER
SENSOR WIRE HERE.
ELECTRODE INTERNAL
MOUNTING POINT.

Removing the Cylinder

WARNING
Disconnect main power at the external
disconnect before any servicing.
The inside of the humidifier cabinet contains high
voltage components and wiring. Access should be
limited to authorized personnel.
1. Drain the existing cylinder by switching the On/Off/
Drain switch to the Drain position. Let the humidifier
drain until no more water is flowing out to drain
(usually not more than 10 minutes).
2. Turn the humidifier On/Off/Drain switch to off.
3. Close supply water shut off valve.
33-00159EFS—01
NOTE: Honeywell recommends keeping a replace-
ment cylinder in stock throughout the humid-
ification season. This will prevent possible
downtime when the humidifier reports cylin-
der end of life.
STEAM OUTLET
SECURE STEAM HOSE TO
OUTLET WITH HOSE CLAMP.
Fig. 2. HM700 Cylinder
4. Turn off power to the humidifier with the external
disconnect.
5. Remove the two screws securing the front cover.
6. Remove the cylinder plugs from the cylinder pins by
pulling vertically.
7. Using a flat screwdriver loosen the hose clamp
where the hose is connected to the cylinder.
8. Tip the top of the cylinder forward to pivot it out of
the steam hose. When free of steam hose lift the
cylinder out.
NOTE: The HM700 has a re-usable tie strap to
2
ELECTRODE PIN
CONNECT COLOR CODED CYLINDER
PLUGS TO PIN WITH CORRESPONDING
COLOR LABEL. THE SPRING LOADED
PLUG SHOULD FIT SNUGLY ON THE PIN.
REPLACE IF LOOSE OR ANY SIGNS OF
DAMAGE.
LABEL
IDENTIFIES CYLINDER INFORMATION.
ALSO INCLUDES SAFETY INFORMATION
AND CONTACTS.
secure the cylinder for transit as well as
home installation. This must be
removed or loosened to remove the
cylinder.
M35704