Tools Required - Troy-Bilt TB575 EC Manual De Operador

APPLiCATiONS _@
As a trimmer:
Oil Fill
Plug
" Cutting grass and light weeds.
• Edging
= Decorative trimming around trees, fences, etc.
Other optional accessories may be used. Spark
Plug
Muffler
\
TOOLS REQUIRED:
= #2 Phillips screwdriver
= 3/8" Socket
Starter
On/Off Stop
Fuel
Cap
Line Cutting
Blade
D-Handle Shaft
Grip
ThrotUe
Control
Choke
Primer
Bulb
INSTALL CUTTING ATTACHMENT SHIELD
A_, I WARNING:
To prevent serious personal injury, never operate
i
the tr mmer w thout the cutt ng attachment she d n p ace. | J
Use the following instructions if the cutting
attachment shield on your unit is not installed.
Use only the instructions that apply to the type of
shaft and shield that your unit is equipped with.
1. Place the cutting head shield onto the guard
mount bracket, making sure to align the
holes on the shield with the holes in the
guard mount bracket. (Fig. 1)
2. Take the 2 shield screws and screw each
one into the shield until finger tight.
3. Using an appropriate screw driver, tighten
the screws until the shield is firmly in place.
Make sure the screws are tightened equally
so there is a balanced gap between the
bracket and the shield on each side.
ADJUSTING THE D=HANDLE
1. Loosen the bolt on the handle just enough
to move it (Fig. 2).
2.
3.
Screw (2)
y
t
Cutting Guard
Head Shield Mount
Bracket
Fig. 1
6 in. _'_%_k/'_J2Y
(15.24 cm) "t_.'_1_ _
Minimum _
Fig. 2
While holding the unit in the operating position (Fig. 13), move the D-
handle to the location that provides the best grip.
Tighten the bolt until the D-handle is secure. (Fig. 2)
Cutting Head Shield Air Filter
Cover
3uttiag Head