Vertilux VTi Celtic Manual De Programación página 9

Adding an additional remote control or
"cloning" a channel
A previously programmed remote control can be used in order to add a new remote control or
operating channel. Also, you can copy one channel to another in the same remote control using
this procedure.
1.
Using the previously programmed
remote, select the desired channel using the
channel selector button, press and hold the
button for about 5 s until the
motor starts flashing RED.
2. Using the new remote, select the desired
channel using the channel selector
then press the up button. The led indicator will
flash BLUE 3 times. The motor is now set on the
new remote control or channel.
Deleting a single motor or channel
This is convenient when there has been a programming mistake and it is required to delete the
programming from a single channel. Also if you want to delete a programmed motor in a single
channel, turn off the power supply of all motors previously programmed in this channel except the
one you want to delete and follow this procedure.
1. Select the desired channel using the
selector button, and press and hold the
button for approximately
indicator on the motor starts flashing RED.
2. Press the down button
LED indicator flashes
channel has been deleted. Drapery motors
previously linked to this channel are not linked
anymore.
vertilux.com
8
© 2019. Vertilux, Ltd. All Rights Reserved. Last revised: February 2019.
Vertilux
stop
LED indicator on the
button, and
channel
stop
5 s until the LED
for about 2 s until the
BLUE 3 times. The selected
PREVIOUSLY
PROGRAMMED
REMOTE CONTROL
NEW REMOTE
CONTROL
OR CHANNEL
STOP
BUTTON
DOWN
BUTTON
STOP
BUTTON
UP
BUTTON