Optional Functions - Vertilux VTi Celtic Manual De Programación

Initial programming sequence
Before starting...
Check that the motor is compatible with the associated track and accessories and that it is correctly
installed into the end adapter
end adapters that come with the motor, also known as main and secondary control.
Place the motor shaft into the control and
locking bar
pull the safety
Note:
to remove the motor from the main control
LOCKING BAR
pull the
1
Pair the motor with the remote control.
2
Operate the motor in both directions until the main
carrier reaches one end side of the track, and then
the opposite one, allowing the motor to automatically
self-adjust its electronic limits.

Optional functions

• Checking the traversing direction
• Adding an additional remote control or "cloning" a channel
•
Deleting a single motor or channel
•
Deleting the motor from all channels
•
Resetting the motor to factory default
vertilux.com
2
© 2019. Vertilux, Ltd. All Rights Reserved. Last revised: February 2019.
(fig. 1). Be aware that the motor can be installed in any of the 2 track
While downwards, move the
locking bar
downwards. safety
Fig. 1. Sequence to install the motor into the main control
and push it to the left side.
Then, release the safety
to the right. to secure the motor in the control.
locking bar
LOCKING BAR