Stopping The Generator; Oil Sensor; Wattage Information - IMER MASTER 6010 DXL15 YN DE Manual De Usuario

[WELDING MODE]
Connect the wire of the ground jaw to the plug (1). Connect the ground jaw to the part to weld.Connect
the wire of the electrode-holder to the plug (4). Select the range of power using the switch (3). Select
the welding power using the switch (2) (the black scale is for the low range, the blue scale is for the
medium range and the red scale is for the high range).
During the welding, alternator plugs are live but the voltage is both low and not stable. Therefore,
for safety reasons, we recommand to unplug all equipments.
The alternator is designed to produce a maximal power over a limited period. Over this period, a
cooling time is required (see indication 6 on the plate)Therefore, when working using high power
triggers the thermal protection, please wait several minutes before resetting this thermal protection.

6. STOPPING THE GENERATOR

1. Turn off the power switch of the electric equipment and unplug the cord from the receptacle of
the generator.
2. Allow the engine about 3 minutes to cool down at no-load before stopping.
3. Turn the key to the OFF position (STOP). Fig.
4.
When storing the generator, always turn the key to the OFF position. Otherwise, in case the
generator is not used over a long period, the battery may discharge.

7. OIL SENSOR

1. The oil sensor detects the fall in oil level in the crankcase and automatically stops the engine when
the oil level falls below a predetermined level.
2. When engine has stopped automatically, switch off generator's no-fuse breaker, and check the oil
level. Refill engine oil to the upper level as instructed on page 8 and restart the engine.
3. If the engine does not start by usual, consult your nearest IMER dealer or service shop.

8.WATTAGE INFORMATION

Some appliances need a «surge» of energy when starting. This means that the amount of electrical
power needed to start the appliance may exceed the amount needed to maintain its use. Electrical
appliances and tools normally come with a label indicating voltage, cycles/Hz, amperage (amps) and
electrical power needed to run the appliance or tool. Check with your nearest dealer or service center
with questions regarding power surge of certain appliances or power tools.
•
Electrical loads such as incandescent lamps and hot plates require the same wattage to start as is
12
EN
FR
ES
IT
RO
13