Hammerhead HLCL360 Manual De Instrucciones página 11

OPERATION
5. SELF-LEVELING MODE
Your self-leveling 360-degree cross
line laser has two working modes:
self-leveling mode and lock (manual)
mode. In self-leveling mode, the tool
will level itself if it is within ±4° of
horizontal.
a. Place the self-leveling
360-degree cross line laser on
a flat, smooth surface that is
within ±4° of horizontal.
b. Turn the tool on by sliding
the power switch in the direction of the "ON" arrow. The self-leveling
360-degree cross line laser will automatically level within 4 seconds. The
LED indicator will illuminate in green.
c. Press the mode button until the desired laser-projection mode is achieved
and the laser line is projected from the laser aperture.
d. If the surface on which the self-leveling 360-degree cross line laser is
placed exceeds ±4° from horizontal, the laser line will blink as an alarm
and the LED indicator will illuminate in red. In this event, adjust the angle
of the surface slightly.
e. To turn off the laser lines, slide the switch in the direction of the "OFF"
arrow.
SELF-LEVELING 360-DEGREE CROSS LINE LASER
5
11