Operating Elements; Before Commissioning - Bona PowerScrubber Manual De Instrucciones

25
24
1 Lock for fresh water reservoir
2 Switch for brush drive
3 Switch for detergent solution
4 Hose for detergent solution
5 Lint sieve (suction)
6 Lock of pushing handle
7 Release button for the transport wheel
8 Transport wheel
9 Push handle
10 Strain relief clamp
11 Support of the transport wheel
12 Clip
13 Fresh water tank
14 Dirt water reservoir
15 Push-button for vacuum bar change
16 Float
17 Button for brush change
18 Chassis
19 Vacuum bar
20 Brushing rollers
21 Rotating handle for brush contact pres-
sure
22 Pedal to lower vacuum bar
23 Mains plug
24 Carrying handle for wastewater reservoir
25 Fresh water tank cover

Operating elements

Before Commissioning

Installing the pushing handle
 Slide the upper slider half onto the low-
er slider half.
Caution
Risk of damage. Do not pinch the cable
during the installation.
 Align the borings (2 possible height ad-
justments).
 Connect the slider halves to the lock
screws, discs and star grips.
 Fasten the cable to the slider using
clips.
2
-
EN
Installing the transport wheels
 Insert the transport wheel axles into the
borings on the appliance and lock them.
Installing the Brushes
The brushes must be installed before the
initial operation (see "Maintenance works").
Operation
Note
To take the brush drive out of operation, im-
mediately release brush drive switch.
11