Bona PowerScrubber Manual De Instrucciones página 14

Ocultar thumbs Ver también para PowerScrubber:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
Faults
Danger
Risk of electric shock, risk of injury!
Pull the plug from the mains before carrying
out any tasks on the appliance.
Fault
Appliance cannot be started
Insufficient water quantity
Insufficient vacuum performance
Insufficient cleaning result
Brushes do not turn
Appliance vibrates.
14
Caution
Risk of damage to the appliance on ac-
count of water leakage. Drain out dirt water
and the remaining free water before wok-
ring at the machine.
In case of faults that cannot be remedied
using the table below please contact Bona-
customer service.
Remedy
Check if the mains plug is connected.
Socket fuse rating too low, look for proper socket.
Check fresh water level, refill tank if necessary.
Clean the ball valve in the fresh water reservoir.
Check and ensure that the fresh water reservoir is seated properly on the appliance.
Filter in the fresh water reservoir is plugged, clean filter.
Pull out the water distribution bars above the brushes and flush with water.
Check hoses for blockages; clean if required.
Empty the wastewater reservoir.
Check and ensure that the fresh water reservoir is seated properly on the wastewater reservoir.
Check seals on the fresh water reservoir, clean if necessary.
Clean the seals between the appliance and the dirt water reservoir and check for tightness, re-
place if required.
Clean the fluff filter.
Clean the vacuum lips on the vacuum bar, replace if required
Suction channel plugged, clean.
Check if the vacuum bar is plugged, remove plug if required
Increase brush contact pressure.
Check the brushes for wear, replace if required.
Use brush rollers suited for the type of dirt and floor covering.
Check if foreign matters block the brushes; remove foreign matter if required.
Reduce contact pressure.
Overcurrent protective switch was triggered. The overcurrent protective switch will allow the op-
eration after max. one minute.
Brush rollers are deformed because they were not unloaded by tilting the slider vertically when
parking the appliance; replace brush rollers.
EN
5
-

Publicidad

Tabla de contenido
loading

Productos relacionados para Bona PowerScrubber

Tabla de contenido