Operating Peripheral Equipment Using The Remote Control; Programming The Remote Control Code; To Find A Code Not Listed In The Index - Panasonic TC-32LX300 Manual De Instrucciones

Operating peripheral equipment using the remote control

Programming the remote control code

You can operate other manufacturers' components using this TV's remote control.
Preparations:
• Connect the power cord of the external component to the wall outlet.
• Make sure the component is turned off.
POWER
TV VCR DVD
DTV RCVR
DBS/CBL
TV/VIDEO A -ANTENNA - B
CH
OK
VOL VOL
MENU CH
1 2
4 5
7 8
R-TUNE
0
SWAP SPLIT
REW PLAY
PAUSE
STOP
SPLIT CH
TV/VCR DVD/VCR CH
TV
50
1
POWER
SAP
LIGHT
AUX
2
TV
DTV
3
EXIT
3
Notes:
6
• If the component does not operate with the remote control, repeat the procedure
using another code. (Some brands have multiple codes.)
9
• If an incorrect code is entered, or if the procedure takes longer than 30 seconds,
the programming will fail.
PROG

To find a code not listed in the index

FF
1
REC After selecting the type of component (step 2, above)
OPEN/CLOSE
2
Press and hold POWER and OK together, for
CH
at least 5 seconds.
+
OK
VOL VOL
• The mode selection buttons flashes, and then
CH
VCR DVD
Select the type of the component.
RCVR AUX
DBS/CBL • The selected button lights and all others go
1 2 3
Enter the 3-digit infrared code (see pages 51-53).
• Factory default setting : Panasonic
4 5 6
• Press POWER to test the operation.
7 8 9
0
CH
Press to select the code.
• The code starts from the current device.
VOL OK VOL
• Press POWER button to test the operation.
CH • Repeat the steps until the component code is found.
It may take many attempts before the correct code
is found.
Press to store the code.
CH
VOL OK VOL
CH
release the POWER and OK buttons.
out.