11. Seasonal Stoppages; 12. Operation Of The Display; Display General Information; Functions Of The Display's Buttons - Bio Bronpi CAROL-MIXTA Instrucciones De Instalación, Uso Y Mantenimiento

Please, bear in mind that the stove could need to be cleaned before this 1200 hours established by default or even after them. This depends
on the quality of the fuel used, the smoke installation, and the proper regulation of the stove.
In the following table (also stuck on your stove in the fuel tank cover) you can check the periodicity of the maintenance tasks and who must
do it.
CLEANING TASKS
Remove the cast iron grate of the combustion chamber. Remove the ash helped by a vacuum-cleaner.
Hoover the ashes placed on the burner.
Get free the holes of the burner removing the burner and helped by a sharp item.
Operate the scrapers doing a movement from down to up several times.
Empty the ash pan or vacuum the ash compartment when necessary.
Vacuum the bottom of the pellet tank when necessary.
Clean the internal of the combustion chamber suck in the walls with a correct vacuum cleaner.
Clean the smoke extractor engine, the whole combustion chamber, pellet tank, whole replacement of the seals and
put again silicone where necessary, smoke duct, registers...
Check all the electronic components (electronic board, display...)
Check all the electrical components (resistance, smoke extractor engine, turbine...)

11. SEASONAL STOPPAGES

If the stove will not be used for a long time it is convenient keep the fuel tank empty (pellet), such as the screw-type conveyor to avoid
the fuel compacting and clean the stove and the smoke duct, removing the whole ashes and others residues, close the stove door. It is
recommended to clean the chimney at least once a year. Meanwhile, check the joints because if they are not in good condition (they do not
adjust to the door), they do not guarantee the proper operation of the stove! For this reason, it would be necessary to change them. You can
find this spare part in the same Bronpi distributor where you bought your stove.
If there is humidity in the place where the stove is installed, put absorbent salts inside the equipment. Protect the internal parts with neutral
vaseline in order to keep the appearance along the time.
If you want you can disconnect the stove from the electrical network, but remember that if the disconnection time is so long, the alarm "Er11"
will show when connect again the stove and you should readjust the date and hour of the stove.

12. OPERATION OF THE DISPLAY

12.1.

DISPLAY GENERAL INFORMATION

The display shows information about the stove performance. Once you gain
access to the menu, you can get different types of screen and adjust the
available configuration according to the level of access. Depending on the
working mode, the display may have different meanings depending on the
position in the screen.
The display shows the time, the chrono activation, the working power,
heating power, working state/alarm code, set-point temperature, the room
temperature, leds, etc.
12.2.

FUNCTIONS OF THE DISPLAY'S BUTTONS

The following table shows the meaning of each key of the display as well as its function:
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
11:30
30º
20º
Service
34
11:30
30º
20º
Run Mode
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
P4
P1
P2
P3
P5
CAROL-MIXTA