Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Setup with Multiple Sensors
The clock can receive up to 3 outdoor sensors: W186-D.
Select a separate channel on each outdoor sensor.
•
Install batteries in all the sensors.
•
Hold the CH button for 5 seconds and the clock will
•
search for all outdoor sensors.
Press the TX button once on each sensor to send a
•
signal.
Search for Outdoor Sensor
Hold the CH button to search for the outdoor sensor.
•
Press the TX button on the sensor to send a signal.
•
Restart
If there is no outdoor temperature data after 3 minutes,
remove batteries from the clock and the outdoor sensor then
press any button 20 times. After 15 minutes, return to Step 1
above.
Outdoor Sensor Positioning
Mount the outdoor sensor on a north-facing wall or in any
•
well shaded area. Under an eave or deck rail is preferred.
The maximum wireless transmission range to the clock is
•
over 100 feet (30 meters) in open air, not including walls or
floors.
Be sure the outdoor sensor is mounted vertically
•
Care & Maintenance
Do not mix old and new batteries
•
Do not mix Alkaline, Standard, Lithium or Rechargeable
•
Batteries
Always purchase the correct size and grade of battery most
•
suitable for intended use.
Replace all batteries of a set at the same time.
•
Clean the battery contacts and also those of the device prior
•
to battery installation.
Ensure the batteries are installed with correct polarity
•
(+and -).
Model: 512-811-BBB
www.lacrossetechnology.com/support
| 5
Publicidad
Tabla de contenido
