Electrical Connection - Bobrick QuietDry Serie Instrucciones De Instalación

Secadores de manos bobrick
Ocultar thumbs Ver también para QuietDry Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 4
FOR PROPER ELECTRICAL CONNECTIONS, CHECK LOCAL BUILDING CODE. UNIT MUST BE INSTALLED BY A QUALIFIED
LICENSED ELECTRICIAN
1. Connect dryer to nearest distribution panel. Use wire as required by local electrical code. In the United States and Canada use
No. 12 wire or larger.
2. Wiring Instructions:
a. This appliance is intended for connection to fixed wiring.
b. A fused means for disconnection in all poles must be provided in the fixed wiring in accordance with the wiring rules.
c. Check that the electrical rating shown on the Hand Dryer (rating label) is compatible with the electrical supply.
d. WARNING: THIS PRODUCT MUST BE EARTHED.
e. Installation and wiring must conform to current IEE Regulations (UK), local or appropriate regulation (other countries).
f. For 115 Volt Dryers: Connect ground/earth supply the terminal marked
supply to terminal marked N. A DEDICATED LINE IS REQUIRED FOR EACH 115 VOLT DRYER.
g. For 208–240 Volt Dryers: Connect ground/earth supply the terminal marked
marked L (L1) and N (L2).
3. Secure electrical wire in strain relief clamp provided on mounting base.
B
1. Replace cover by positioning top of cover on studs on top of
mounting base and tipping bottom of cover toward wall. Push
bottom of cover firmly against wall.
NOTE: Space between cover and wall must be the same on four
sides.
1. For AutoPilot Hand Dryers: Turn electrical power supply on. Position hands under nozzle and
dryer should turn on. Remove hands from under nozzle and dryer should stop.
WARNING: MOTOR LAMINATIONS ARE LIVE. TURN ELECTRICAL POWER SUPPLY OFF BEFORE DOING ANY
MAINTENANCE OR SERVICE TO DRYER. DRYER MUST NOT BE OPERATED UNLESS COVER IS IN PLACE.
FOR PROPER ELECTRICAL CONNECTIONS, CHECK LOCAL BUILDING CODE. UNIT MUST BE INSTALLED BY A QUALIFIED
LICENSED ELECTRICIAN
1. Exterior of cover should be cleaned with a damp cloth to remove dust and surface dirt. Do not use abrasive agents or solvents as
they may
permanently damage surface of cover.
2. At least once every 6 months remove cover. Using a small brush or vacuum, clean out buildup of dust and lint from air-intake grille
and baffle.
NOTE: if dryer is installed where there is a lot of dust and dirt in the air, the interior of the dryer should be cleaned out more
frequently.
Form No. 7180-7188-69_ii Multi Language (Revised 2/3/16)

Electrical Connection

Replace Cover
A
Check Dryer Operation
Maintenance
, the Live supply to terminal marked L and neutral
and the 208-240 Volt wires to terminals
2. To tighten two cover bolts,
insert Allen wrench into
holes on bottom of cover.
Make sure wrench fits into
head of cover bolts and
turn COUNTERCLOCKWISE
until bolts are tightened.
NOTE: Do not overtighten cover
bolts; overtightening cover bolts
may damage enamel finish.
© 2016 Bobrick Washroom Equipment, Inc.
x 2
3
Printed in U.S.A.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

TerradryB-7180B-7188

Tabla de contenido