Electrical Connection - Bobrick Elan B-715 Instrucciones De Instalación

for ProPer eLectricAL coNNectioNs, checK LocAL BuiLdiNG code. uNit must Be iNstALLed By A QuALified LiceNsed
eLectriciAN
1. Connect dryer to nearest distribution panel. Use wire as required by local electrical code. In the United States and Canada use No. 12 wire or
larger.
2. Wiring Instructions:
a. This appliance is intended for connection to fixed wiring.
b. A fused means for disconnection in all poles must be provided in the fixed wiring in accordance with the wiring rules.
c. Check that the electrical rating shown on the Hand Dryer (rating label) is compatible with the electrical supply.
d. WARNING: THE 115 Volt Dryer MUST BE EARTHED.
e. Installation and wiring must conform to current IEE Regulations (UK), local or appropriate regulation (other countries).
f. for 115 Volt dryers: Connect ground/earth supply the terminal marked
terminal marked N. A dedicAted LiNe is reQuired for eAch 115 VoLt dryer.
for 208–240 Volt dryers: Connect the 208-240 Volt wires to terminals marked L (L1) and N (L2).
g.
3. Secure electrical wire in strain relief clamp provided on mounting base.
1. Fit cover over mounting base. NOTE: Four sides of cover overlap the
mounting base and should be flush with the sides, top and bottom of
the mount ing base.
1. Turn electrical power supply on.
2. Position hands under air-outlet, within 4'' (100mm) of the bottom of the dryer.
3. Dryer should turn on. Warm air should blow from air-outlet.
4. Remove hands from under air-outlet and dryer should stop (within 2 seconds).
1. Exterior of cover should be cleaned with a damp cloth to remove dust and surface dirt. Do not use abrasive agents or solvents as
they may permanently damage surface of cover.
2. At least once every 6 months remove cover. Using a small brush or vacuum, clean out buildup of dust and lint from air-intake grille
and baffle.
NOTE: if dryer is installed where there is a lot of dust and dirt in the air, the interior of the dryer should be cleaned out more frequently.
Form No. 715-69 Multi Language (Rev. 3-29-16)

Electrical Connection

Replace Cover
2. Replace and tighten three screws, one on each side and one on the
bottom to secure cover to mounting base.
Check Dryer Operation
Maintenance
© 2016 Bobrick Washroom Equipment, Inc.
, the Live supply to terminal marked L and neutral supply to
Printed in U.S.A.
3