Using The Xps 101 Speaker System - Hercules XPS 101 Manual Del Usuario

3. USING THE XPS 101 SPEAKER SYSTEM

1. Turn on the audio source you wish to use (PC, television set, DVD player or game console).
2. Power on the speaker system by pressing the main knob on the remote control (10). The
"power" and "volume" LEDs (11-Power and Vol.) light up on the remote control.
3. Adjust the volume by turning the main knob on the remote control (10): the "+" or "-" LED
flashes for each step you make in increasing or decreasing the volume. If the volume is already at
the maximum or minimum setting and you try to set it even higher or lower, the corresponding
LED remains lit up (without flashing) while you are turning the knob, indicating that the volume
can't go any further in that direction.
4. To adjust the bass level, press and release the main knob on the remote control (10): the bass
LED (11-Bass) lights up.
5. Adjust the bass level by turning the main knob on the remote control (10): the "+" or "-" LED
flashes for each step you make in increasing or decreasing the bass level. If the bass level is
already at the maximum or minimum setting and you try to set it even higher or lower, the
corresponding LED remains lit up (without flashing) while you are turning the knob, indicating that
the bass level can't go any further in that direction.
6. Press the main knob on the remote control (10) again to adjust the treble level. The treble LED
(11-Treble) lights up and, as described previously, the "+" or "-" LED flashes for each step you
make in increasing or decreasing the treble level. If the treble level is already at the maximum or
minimum setting and you try to set it even higher or lower, the corresponding LED stops flashing.
7. To switch between adjusting the volume, the bass level and the treble level, briefly press the
main knob on the remote control (10). After 10 seconds of inactivity in "bass level adjustment" or
"treble level adjustment" mode, the system automatically reverts to the master volume adjustment
mode.
8. To put your XPS 101 speaker system in standby mode, press and hold the main knob on the
remote control (10) for more than 3 seconds: the LEDs (11) go off. Your speaker system's power
consumption in standby mode is less than 1W, in compliance with the EC 1275/2008 standard.
9. Your volume, bass level and treble level settings are saved; however, your settings will no
longer be saved if you unplug the speaker system's power cable.
When you connect an audio source to the Line In connector on the remote control, the
main audio source is disabled.
When you connect headphones to the remote control, the satellites and the
subwoofer are automatically disabled, and only the headphone output is enabled.
8/10 – User Manual