During Treatment - SMA LIGHT 360 Manual De Usuario

Only if you experience little or no discomfort during and after use of the devise energy at the
lowest energy setting, you can increase the energy level, and so on for each subsequent session.
For detailed instructions on energy level setting, see "Energy Level".
Always shave the area to be treated and make sure the skin is clean and dry before using the
appliance.
Cover tattoos, lips and nipples before applying the appliance.
Cover dark brown or black spots, such as large freckles, birth marks, moles or warts before
using the appliance.
Never use flammable liquids such as alcohol (including perfumes, sanitizers, or other
applications containing alcohol), or acetone to clean the skin before using the appliance.
Do not use the appliance on any body part where you might later want hair.
PATCH TEST
Before you begin the treatment, it is recommended that you perform a patch test to identify
your skin's highest level of tolerance to the pulsed light. For instructions on how to perform a
patch test, see "Inspection before use" section.

DURING TREATMENT

Not treat the same area of skin more than once per
session! Do not repeat the spots.
If blisters are formed on the skin, or if the skin burns, IMMEDIATELY STOP USING THE
APPLIANCE.
Always make sure that the treatment surface points toward the skin, and is completely in
contact with it.
Remove the surface treatment (11) from the skin if it becomes excessively hot.
7
INSTALLATION
1) Assembling the Lights
A
B
C D
Pay attention to the direction of insertion. There are 3 plastic pivot hinges (A C D) found
behind the light and an electronic card (B). During installation of the light, be careful to match
these elements with their corresponding housings on the machine's attachment. Installation
and removal of the light does not require equipment and is hand-made when the Machine is
off and disconnected from the power socket, note
that the lights are dismantled by pulling outward on
one side as indicated in the drawing on the side, do
not remove the light by pulling horizontally because
it would risk damaging the plastic.
2) Insert the Power Connector (6) in the power socket (3)
A
B
C
D
8