Ip Protection Degree; Electrical Insulation Degree; Declaration Of Absence Of Dangerous Substances; Fixed Closure Guards Safety - Sistem-Air Tecno R-evolution 150 Manual Tecnico

• Wear protective gloves and mask to carry out maintenance, to empty the dust bin or replace and clean
the fi lter.
• Only use original spare parts and accessories.
• Do not use the system without a fi lter cartridge.
• Do not block the exhaust air pipes or the motor cooling intakes.
• No part of the body should come into contact with the suction accessories.
• Use only one suction socket at a time.
• Do not leave the system switched on when not using it and disconnect it from power supply when the
system is not to be used for a long period of time.
Finally, remind that pictograms or danger and warning signals can be found on those parts of the
equipment where, if not strictly followed, potential risky situations may occur.

4.2 IP Protection Degree

IP 44: The appliance features a protection against solid objects having a size exceeding
1 mm and protection against splashes of water (splashes of water from any direction on
the cover must not produce dangerous effects).
IP 20: Apparatus protected against solid parts larger than 12 mm but not protected against
IP20
the infi ltration of water.

4.3 Electrical insulation degree

CLASS I: the appliance features basic electrical insulation.
Must be connected to the ground circuit through the main electric circuit.
5.2 Electrical insulation degree
CLASS II: the appliance features double electrical insulation. They doesn't need a connetion
to the ground circuit through the main electric circuit.

4.4 Declaration of absence of dangerous substances

TECNOPLUS S.r.l. declares that its products and appliances have been manufactured with materials
which comply with the restrictions established by the health and environment protection regulations in
force and do not contain SVHC-classifi ed substances (Substance of Very High Concern) in compliance
with CE regulation 1907/2006 (REACH: i.e. Registration, Evaluation, Authorization and Restriction of
Chemical Substances). Although these substances have not been used during the processing cycles of
raw materials and during the manufacturing cycles of our products, their presence in p.p.m. (parts per
million) cannot be completely excluded due to micro-pollution of raw materials.

4.5 Fixed closure guards safety

The vacuum cleaner is delivered to the Customer with its main body completely assembled. Moving parts
(suction motor turbine blades) are protected by a protection grid directly assembled on the inlet of the
suction motor compartment. This protection grid cannot be accessed by the operator. The operator also
does not have access to the electrically-operated parts of the appliance which are protected by a cover
which can only be removed by unscrewing the Torsen screws used to fi x the soundproofi ng dome of the
housing where the suction motors are assembled.
Every intervention on the control board and on the motors must be carried out by qualifi ed personnel only
after disconnecting the electrical power supply and by removing the electric plug from the electric socket.
12/05/16 Rev:1.0.0
2
5