Sistem-Air Tecno R-evolution 150 Manual Tecnico página 35

6.3 Fixing the vacuum cleaner to the wall
The vacuum cleaner must be securely and permanently fi xed to a solid wall using the bracket provided
and the suitable wall anchors or plugs taking into account that the total weight to be supported can be
seven/eight times that of the system itself.
The system should be positioned high enough off the ground to allow the dust collection bin to be
emptied and the fi lter to be replaced in a simple way.
Position the system so as to keep a minimum distance of 60 cm around the appliance for extraordinary
maintenance.
To do this follow the instructions detailed below:
Tighten the screws in
the wall plugs and check
that the bracket is well
anchored to the wall.
Hook the vacuum cleaner to the
anchoring bracket by lifting it, leaning
it against the wall and allowing it to
slide down until it fi ts into the fi xing
plate.
12/05/16 Rev:1.0.0
Trace the drilling position using the
1
template provided (drilling template); if
this has already been done, proceed to
the next step.
NB: see page 2 for X measure
3
Drill the holes
2
4
2
9