Inserting The Navi Microsd Card; Inserting And Charging Batteries In The Handheld Device - ASPERIUM RAPTOR Manual De Instrucciones

INSERTING THE NAVI-MicroSD CARD
(1)
A
6
Remove the locking screw (1) on the back of the handheld
device A and remove the battery cover.
The MicroSD card holder is located underneath the
batteries. Carefully unclip the holder (2) in the direction
open and lift.
Insert the MicroSD card (3) with the gold contacts facing
downwards and click the holder in the direction lock.
ASPERIUM RAPTOR – USER MANUAL

INSERTING AND CHARGING BATTERIES IN THE HANDHELD DEVICE

Remove the battery cover (1) from the back of the device and insert the Li-ion batteries F included
in the scope of delivery into the battery compartment taking care to match the polarities.
NOTE: Please only use the Panasonic/Sanyo 3.7V Li-ion batteries, type UR14500P supplied by ASPERIUM.
Inserting any other types of battery into the device will lead to damage or a loss of output.
Before operating the handheld device for the first time, the batteries must be charged.
To do this, open the dust cover (2) and connect the handheld device to the USB charger G using the cable D.
Use the USB charger to charge the batteries installed in the handheld device either by means of the 110V/220V power
cable or in your vehicle using the 12/24V adapter.
The charging time is approx. five hours for completely depleted batteries.
The charging time will be longer if the handheld device is switched on or the transmitter is connected.
(2)
(3)
(1)
ASPERIUM RAPTOR – USER MANUAL
(2)
F D G
7