Operation Tips; Maintenance; Clean The Machine; Lubricate The Blade - GreenWorks Pro PH60L210 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about a hand's width below your right hip.
9.5

OPERATION TIPS

Start by trimming the top of the hedge. Slightly tilt the
tool (up to 15° relative to the line of cut) so that the blade
tips point slightly towards the hedge. This will cause the
blades to cut more effectively. Hold the tool at the desired
angle and move it steadily along the line of cut. The
doublesided blade allows you to cut in either direction.
In order to obtain a very straight cut, stretch a piece of
string along the length of the hedge at the desired height.
Use the string as a guideline, cutting just above it.
In order to obtain flat sides, cut upwards with the growth.
Younger stems move outwards when the blade cuts
downwards, causing shallow patches in the hedge.
Take care to avoid any foreign objects. Especially avoid
hard objects such as metal wire and railings, as these
could damage the blades.
Regularly oil the blades.
Keep hands away from blade while operating. Contact with
blade will result in serious personal injury.
10

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
CAUTION
CAUTION
English
Remove the battery pack from the machine before
maintenance.
10.1

CLEAN THE MACHINE

Keep the machine and the motor free of leaves, branches or
excessive oil to prevent fire risks.
Use a moist cloth with a mild detergent to clean the
machine.
Clean all moisture with a soft dry cloth.
Use a small brush to clean the air vents.
10.2

LUBRICATE THE BLADE

To increase the efficiency and life of the blades, lubricate
them carefully after each work session:
Put the machine on a flat and smooth surface.
Use a soft cloth to clean the blades and a brush to remove
more dirt.
Use a light layer of oil to lubricate the blades along the
top edge of the blade.
We recommend to use the non-pollutant type oil.
11

STORE THE MACHINE

Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
10
WARNING
WARNING
NOTE
NOTE

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Ph60l00Ptc401

Tabla de contenido