AKASO A200 Manual De Usuario página 3

English
CONTENTS
USB Charging wire
A plane
REMOTE DIAGRAM
Speed
Throttle/Rotate( yaw)
Headless mode
Start / landing
Photo
One key return
Video
LOADING BATTERIES INTO THE ROMOTE
Open the battery Put in 4 AA batteries
compartment by loosening with correct directions.
the screws on the cover
with a screw driver.
2 PCS Main Blade Screw driver
User Manual
AKASO A200 Quadcopter
Protective cover Instructions for operation
Flipping
Power switch
Directional Control (pitch/roll)
Forward tuning
Emergency stop
Right side tuning
Backward tuning
Left side tuning
Put on the cover and
fasten the screws.
1
CHARGING LI-PO BATTERY
Turn off the power switch of the quadcopter, then push-down and slide open the battery
compartment. Disconnect the battery from the quadcopter and attach it to the included usb
charging adaptor. Connect the USB charging adaptor to a power source. The indicator light will
come on, and not turn off until charging is complete.
ATTENTION
- Do not use or leave the battery near a heat source.
- Do not disassembl the battery.
- Never leave the battery unattended during charging.
STANDBY FOR FLY
Switch the aircraft power switch to "ON" first, then point the tail of the aircraft towards the
remote and place it flat on the ground. At this point, the vehicle lights flicker. Turn on the remote
control power switch, then hear the remote beep. Push the accelerator (left stick) to the top, and
the lights will flicker slower. Pull the accelerator (left stick) down to the bottom and the remote
will beep again. The lights will stop flashing when successfully coded.
Note: When vsing multiple aircraft, code each remote one at a time.
CALIBRATION
Turn on the transmitter, and match it with the quadcopter by pulling the right and left levers to the
bottom right 45 degrees.
TIPS: After successfully coding the remote, match
it with the quadcopter, when matching signal,
keep the quadcopter in horizontal position
for faster matching.
2