Numatic TEM 390A-11 Manual De Instrucciones página 12

GB
WARNING!
Read the instruction manual before using the machine.
Operators shall be adequately instructed on the use of their machine.
As with all electrical equipment, care and attention must be exercised at all times during use, in
addition to ensuring that routine and preventative maintenance is carried out periodically to ensure safe
operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the
correct standard could render this equipment unsafe and the manufacturer can accept no
responsibility in this respect. Maintenance should only be carried out by a qualified person.
This machine is for DRY USE only and must not be stored outside or used in wet conditions.
The machine shall be disconnected from the mains by removing the plug from the supply socket during
cleaning or maintenance and when replacing parts or converting the machine to another function.
The machine is not to be used by children or persons with reduced physical, sensory or mental
capabilities, or lack of experience or knowledge, unless they have been given supervision or
instruction.
This appliance is intended to be cleaned and maintained by an adult.
Children being supervised are not to play with the machine.
This machine is not a toy.
CAUTION
This machine is not suitable for picking up biological hazards or explosive dust.
Contact your local distributor if you require a machine capable of performing these tasks.
Ensure that the filtration system fitted to the machine is suitable for the material being collected.
This vacuum cleaner is intended for indoor use in the collection of dry materials.
This machine should be stored indoors only.
NOTES
This product complies with the requirements of clause 20 of IEC/EN 60335-2-69 Stability and
Mechanical Hazards.
This machine is also suitable for commercial use, for example in hotels, schools, hospitals,
factories, shops, rental businesses and offices for other than normal housekeeping purposes.
This vacuum cleaner is fitted with a thermal protection device. If the vacuum cleaner stops
working, remove the plug from the wall before investigating where the fault lies.
If the vacuum cleaner has a blockage, switch off, remove the plug from the socket, inspect the floor
tool, tubes and hose for debris. If the floor tool, tubes and hose are clear, replace the dust bag and
clean the filter.
The vacuum cleaner should be inspected after use for damage.
The vacuum cleaner should be stored in a dry place.
DO
• Keep your machine clean including hoses and tubes.
• Change dust bag frequently.
• Keep filters clean.
• Keep diffuser filter (where fitted) clean.
• Use filter bags, they will enhance performance and help keep machine clean.
• Keep hoses and tubes clear.
• Replace any worn or damaged parts immediately.
• Only use the socket outlet on the machine for purposes specified in the instructions.
• Only use the brushes provided with the machine. The use of other brushes may impair safety.
• Regularly examine the power cord. If damage is found such as cracking or ageing the power cord
must be replaced by a qualified person.
• Only replace the power cord with the correct Numatic approved replacement part.
DO NOT
• Pull on the cable to unplug the machine from the power supply.
• Use to suck up hot ashes or lighted cigarette ends.
• Use steam cleaners or pressure washers to clean the machine or use in the rain.
• Immerse in water for cleaning.
• Attempt machine maintenance or cleaning unless the power supply plug has been removed from
the supply outlet.
• Do not use in wet environments or to collect wet materials.
Information for DRY use Vacuum cleaners