Health Zenith DualBrite SL-5316 Manual De Instrucciones

D B
®
ual rite
Replacement
Sensor Head
Model SL-5316
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Patented D B Timer.
®
ual rite
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
Requirements
• Not for use with fluorescent lights.
• The light control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
• Install sensor in accordance with local codes.
OPERATION
Mode: On-Time:
Test 5 Sec
Normal
1, 5, 20 min.
Manual
Until Dawn*
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.
© 2007 HeathCo LLC
Works: Day Night
x x
x
x
/ minutes for
1
2
Put ON-TIME switch on
the sensor bottom to
TEST and the D B
ual rite
switch OFF.
Put the ON-TIME switch in the 1, 5,
or 20 minute position.
MANUAL MODE
Manual mode only works at night be-
cause daylight returns the sensor to
AUTO.
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
Manual mode works only with the ON-
TIME switch in the 1, 5, or 20 position.
Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes, turn the power
off for one minute, then back on. After the calibration
time the control will be in the AUTO mode.
D B
ual
Light comes on half bright for selected time after dusk
(Off, 3 hr., 6 hr., until dawn). Selecting OFF disables this
feature. The motion sensing features will continue to work
as described in this manual. If motion is sensed, the light
turns on full bright for the ON-TIME (1, 5, or 20 minutes)
then returns to dim mode.
TEST
ON-TIME D B
ual rite
®
TEST 1 5 20 Off 3 6 Dusk to
Dawn
AUTO
ON-TIME
TEST 1 5 20
1 Second OFF
then...
... back on.
Move ON-TIME Switch to 1,
5, or 20 minutes
Flip light switch off
for one second then
back on*
TIMER
®
rite
595-5109-13
®