Specifications - Monitor Audio IWA-250 El Manual Del Propietario

Specifications

System Format
Low Frequency Limit
Upper Frequency Limit
Amplifier Power Output
Drive Unit Parameters
Amplifier Classification
Cabinet Switch
EQ Switch
Phase Control
Auto Sensing
Input Level Requirements
Input Impedance
Mains Input Voltage
Dimensions (H x W x D)
Connections
12v Trigger Input
Power Consumption
Weight (unpacked
Monitor Audio reserves the right to alter specifications without notice.
6
Active sub-woofer amplifier
Variable 40 – 120 Hz @ 24dB/Octave
250W @ < 1% THD+N
4 - 8 Ohm Nominal Impedance
Class D amplifier with Switch mode power supply
For use when using the dedicated back box
Music/ Movie/ Impact
Line Level > 3.5mV
Standby after approximately 15 minutes if no signal
AC 110 - 120 V ~ 50/60Hz
AC 220 - 240 V ~ 50/60Hz
(Factory Region Preset)
43.7 x 432 x 263mm
1
3/4
LFE in (Stereo RCA and Balanced), 12v Trigger in
(3.5mm mono mini-jack), left and right speaker output
5 - 12v via 3.5mm mono mini-jack socket
Standby: < 0.5W (ErP approved)
Typical Idle: < 10W
Max Rated: 200W
IWA-250
IWA-250
25Hz
(SMPSU)
0 & 180 degrees
sensed
> 20K Ohms
x 17 x 10 Inch
3/8
4Kg (8lb 12oz)