O P T I O N A L AC C E S S O R I E S
O P T I O N A L AC C E S S O R I E S
STACKING KIT INSTALLATION
Place the dryer on top of the washer by
3
fi tting the dryer feet into the side brackets as
illustrated. Avoid fi nger injuries; do not allow
fi ngers to be pinched between the washer
and dryer. Slowly slide the dryer toward the
back of the washer until the side bracket
stoppers catch the dryer feet.
S P E C I F I C AT I O N S
S P E C I F I C AT I O N S
KEY DIMENSIONS AND SPECIFICATIONS
The appearance and specifi cations listed in this guide may vary due to constant product improvements.
TROMM™ Dryer Models DLE5955W, DLG5955G, DLG5966W, DLG5966G
Description
Electrical Requirements*
Gas Requirements*
Dimensions
Net Weight
Drying Capacity
*Refer to the rating plate on your dryer.
36
(cont.)
Dryer
Washer
TROMM Series Dryer
Please refer to the rating label regarding detailed information.
NG: 10–13 in. WC/LP: 10–13 in. WC (Gas Models only)
11
27"(W) X 30"(D) X 38
/
16
68.6 cm (W) X 76.1 cm (D) X 98.3 cm (H), 129.1 cm (D with door open)
126 lb. (57.2 kg)
IEC 7.3 cu. ft. (22.5 lbs./10.1 kg)
Insert the front rail between the bottom of
4
the dryer and the top of the washer. Push the
front rail toward the back of the washer until it
comes in contact with the side rail stoppers.
Install the two remaining screws to secure the
front rail to the side rails.
"
"(H), 50
(D with door open)