Display - Magnavox MFX-450 Guia Del Usuario

MFX450_eng 11/26/02 3:21 AM

DISPLAY

Display
The display of the receiver is divided into 4 sections, which
are to be used for the following:
Speaker diagram
A rectangle with a letter in it shows that a speaker has been
selected in the setup menu. However, the subwoofer indicator
will only light when a subwoofer signal is available. If only a
letter is shown, this speaker is not used and its sound is
being reproduced by the other speakers.
.....virtual surround sound
.................surround sound is reproduced
SURROUND
DIGITAL SURROUND
, ...........................front left and right speaker
L R
...............................center speaker
C
, .......................surround speakers
SL SR
............................subwoofer
SW
Menu indication
These signs show you if the menu is on or off and indicate in
which direction you may move.
.......................Menu is on.
M M E E N N U U
1..............................You may move backwards to the previous
3 .............................You may move up in an option list using
4 .............................You may move down in an option list
2..............................You may move forward to the next menu
.............................You may confirm the displayed value.
O O K K
16
Page 16
....digital surround sound is reproduced
menu topic using 1 PREV. / EXIT ("left"
key on the remote control).
X MENU NAVIGATOR ("up" key on the
remote control).
using X MENU NAVIGATOR ("down" key
on the remote control).
topic using NEXT 2 ("right" key on the
remote control).
Status lights
Signs show you various settings and information about the
status of the receiver.
......................Tuner is tuned to a preset radio station.
PRESET
.....................Tuner is switched to high sensitivity.
SENS HI
..................Tuner is switched to low sensitivity.
SENS LO
......CINEMA LINK is active
C C I I N N E E M M A A L L I I N N K K O O N N
......................An FM station is being received in stereo.
STEREO
...........One of the preset sound settings of the
SMART SOUND
receiver is being used.
..........................HALL effect is on.
HALL
..........................Analog input is being used for the playing
ANA
source.
.......................NIGHT MODE is on.
N N I I G G H H T T
......................Coaxial digital input COAX 1 is being
COAX 1
used for the playing source.
.....................Coaxial digital input COAX 2 is being
COAX 2
used for the playing source.
.................Incoming multichannel signals are being
D D O O W W N N M M I I X X
reduced to fewer output signals
(depending on the number of speakers).
...........................Optical digital input OPTICAL IN is being
OPT
used for the playing source.
.................LOUDNESS is switched on.
LOUDNESS
Information area
This area is used for feedback of the receiver, tuner
frequencies, menu options, values and scrolling text
messages.