Operating Instructions; Switching On And Off; Operating The Trimmer - Black and Decker GH710 Manual Del Usuario

ATTACHING EXTENSION CORD
• An extension cord retainer
(figure H) is built into the switch
handle that prevents the cord
from coming unplugged. To use
this feature, simply double the
extension cord about 8 inches
(203mm) from the end, and
insert it into the slot (10) in the
end of the handle area. Hook
the loop formed by doubling the
cord over the tab (11). Gently
tug on the cord to insure that it is
firmly retained in the trimmerʼs
handle. Plug the receptacle end of the extension cord into the
plug blades (12) in the trimmer.

OPERATING INSTRUCTIONS

Always use proper eye protection that conforms
to ANSI Z87.1 (CAN/CSA Z94.3) while operating this power tool.
WARNING:
Inspect area to be trimmed and remove any wire,
cord, or string-like objects which could become entangled in the
CAUTION:
rotating line or spool. Be particularly careful to avoid any wire which
might be bent outwardly into the path of the tool, such as barbs at the
base of a chain link fence.
10
H
11
12

SWITCHING ON AND OFF

• To switch the tool on, squeeze the trigger
lever.
• To switch the tool off, release the trigger
lever.
• With the unit on, angle unit and slowly
swing the trimmer side to side as shown in
figure I.

OPERATING THE TRIMMER

• Maintain a cutting angle of 5° to 10° as shown in figure J. Do
not exceed 10°(figure J1). Cut with the tip of the line. To keep
distance from hard surfaces use edge guide (7). Pull the guide out
until it snaps securely into place.
J
5 -10
O O
7
I
J1