Maintenance Instructions - Rotary SPO12 Standard Manual De Instrucciones

If you are not completely familiar with automotive lift mainte-
nance procedures; STOP: Contact factory for instructions.
To avoid personal injury, permit only qualified personnel to
perform maintenance on this equipment.
• Always keep bolts tight. Check periodically.
• Always keep lift components clean.
• Always if oil leakage is observed, call local service represen-
tative.
• Always if electrical problems develop, call local service repre-
sentative.
• Daily: Check cables and sheaves for wear. Replace worn
parts as required with genuine Rotary parts.
• Daily: Check cables and sheaves for wear. Observe for
frayed cable strands. Wipe cables with a rag to detect
hard to see small broken cable strands. Replace cables
showing any broken strands. Replace worn parts as
required with genuine Rotary parts.
WARNING
Clear area if vehicle Position vehicle
is in danger of falling.
with center of gravity
midway between
©
adapters.
WARNING
Avoid excessive
Remain clear of lift
rocking of vehicle
when raising or
while on lift.
lowering vehicle.
©
Do not override Keep feet
self-closing clear of lift
while lowering.
lift controls.
©
The messages and pictographs shown are generic in nature and are meant
to generally represent hazards common to all automotive lifts regardless of
specific style.
Funding for the development and validation of these labels was provided by
the Automotive Lift Institute, PO Box 33116 Indialantic, FL. 32903-3116.
They are protected by copyright. Set of labels may be obtained from ALI or
its member companies.
Ó 1992 by ALI, Inc.

MAINTENANCE INSTRUCTIONS

WARNING CAUTION
Lift to be used
by trained operator
only.
©
WARNING CAUTION
Use vehicle
manufacturer's
lift points.
c
CAUTION
WARNING
Use height extenders
when necessary
to ensure
© good contact.
The messages and pictographs shown are generic in nature and are meant
to generally represent hazards common to all automotive lifts regardless of
specific style.
Funding for the development and validation of these labels was provided by
the Automotive Lift Institute, PO Box 33116 Indialantic, FL. 32903-3116.
They are protected by copyright. Set of labels may be obtained from ALI or
its member companies.
ALI/WL101w
• Monthly: Check equalizer cable tension. Adjust
per lift installation instructions. If there are no
more threads available for adjustment, replace the
cable. Do not use washers to stand off the nut to use
previously used threads.
• Monthly: Lubricate locking latch shafts. Push latch handle
several times for oil to penetrate joints.
• Every 3 Months: Check anchor bolts for tightness
Anchors should be torqued to 65 ft/lbs.
• Semi-Annually: Check fluid level of lift power unit and refill
if required per lift installation instructions.
• If Lift stops short of full rise or chatters, check fluid level
and bleed both cylinders per lift installation instructions.
• Replace all caution, warning or safety related decals on
the lift if unable to read or missing. Reorder labels from
Rotary Lift.
CAUTION
? ?
?
Authorized personnel
only in lift area.
©
©
CAUTION
Always use
safety stands when
removing or installing
© heavy components. ©
CAUTION
Auxiliary adapters
may reduce
load capacity.
© ©
Ó 1992 by ALI, Inc. ALI/WL101c
6
INSPECTION and MAINTENANCE
See ANSI/ALI ALOIM booklet for periodic
inspection checklist and maintenance
log sheet.
SAFETY
SAFETY
INSTRUCTIONS
INSTRUCTIONS
Read operating
Proper maintenance
and safety manuals
and inspection
before using lift.
is necessary
©
for safe operation.
SAFETY
The messages and pictographs
INSTRUCTIONS shown are generic in nature and
are meant to generally represent
hazards common to all automotive
lifts regardless of specific style.
Funding for the development and
validation of these labels was
provided by the Automotive Lift
Institute, PO Box 33116 Indialantic,
FL. 32903-3116.
They are protected by copyright.
Set of labels may be obtained from
Do not operate
ALI or its member companies.
a damaged lift.
©
C 1992 by ALI, Inc.
c
ALI/WL101s