Powering On/Off - Klein Tools ET500 Manual De Instrucciones

ENGLISH
SetUp
CHARGING
The rechargable lithium-ion battery should be charged before operating the
borescope for the first time. The battery can be charged via a standard 120V
wall outlet or through a computer USB port. An exhausted battery will take
up to 5 hours to charge. It can be left charging overnight without needing to
be removed from power. The expected lifetime of the included battery is 500
charging cycles.
WALL OUTLET: Locate the power wall
adapter (g) and the USB cable (h).
Remove the soft input cover and plug
the cable into the borescope's USB
port (18). Plug the other end of the
cable into the power adapter, and plug
the wall adapter into a standard 120V
outlet.
COMPUTER: Locate the USB cable (h).
Remove the soft input cover and plug
the cable into the borescope's USB
port (18). Plug the rectangular end into
your computer's USB port. The LCD
will briefly show a USB illustration then
go dark.
attacHInG tHe GooSeneck caMera
Locate the gooseneck camera (13). Plug it into the camera input socket of the
borescope. Rotate the adjustment
piece clockwise to lock it into place.
The white arrow on the camera head
should be pointing up.

poWerInG on/off

To power the unit on and off, press and hold the Power Button until the splash
screen appears then release it. This usually takes about 3 seconds.
InStallInG an SD carD
The borescope contains a small amount of internal memory to store videos
and photos. To add additional storage, remove the soft input cover and insert
a standard SD/SDHC card face up into the slot until you hear a click. To
remove the SD card, use your fingernail to push it into the slot. You will hear
another click and the card will pop out. See Memory menu section for more
information.
6