Wiring Diagram - Velleman CAMSET19 Manual Del Usuario

4. Wiring Diagram

A 4.2" indoor monitor
B outdoor camera
C PSU
D door lock
E door lock power supply
1 video yellow
2 GND black
3 +12V power red
4 audio green
5 lock A
6 lock B
5. Installation
• Indoor Monitor
• Choose an appropriate installation spot out of direct sunlight. The
recommended installation height is 1.6m.
• Measure the distance between the holes on the mounting bracket and
drill holes accordingly. Place a plug into each hole and fix the bracket
using the screws.
• Wire the videophone according to the wiring diagram.
• Fix the indoor monitor firmly onto the bracket.
• Outdoor Camera
• Choose an appropriate installation spot out of direct
sunlight and rain. The recommended installation height is
1.6m.
• Measure the distance between the holes on the mounting
bracket and drill holes accordingly. Place a plug into each
hole and fix the bracket using the screws.
• Wire the outdoor camera according to the wiring diagram.
• Place the intercom unit firmly into the bracket and tighten
with the screw.
6. Use
• As soon as a visitor presses the doorbell, the videophone will chime and display the image picked up from the intercom
unit. Press to talk (the image will be displayed for 2 minutes). The image will be displayed for 30 seconds if the
button is not pressed.
• The door can be opened by pressing the
unlocking button provided that an optional door latch has been installed
(drive voltage of 12V).
• Press the
button to display the image picked up from the intercom unit at any time. The image will automatically
disappear after 10 seconds.
• Press
to activate the alarm.
• Adjust the volume, the hue and the brightness no using the corresponding adjustment sliders.
CAMSET19 4 VELLEMAN