koban KDP1 360FP Manual De Instrucciones página 33

Choose proper knock-outs to fix the
junction box KDP1 on the surface of
ceiling board with two wood screws
attached with rubber washer (See
FIG.17).
FIG.17
Take off two spring clips of detector
(See FIG.12), turn the decorative
frame of detector anti-clockwise
with proper strength, then insert
the 4 non-dropping screws to the
corresponding screw holes on
detector's front cover.
Afterwards, those 4 screws will not
drop off to provide conveniences
to the subsequent installations (See
FIG.18).
Fixing holes for
ceiling surface
mounting
www.grupotemper.com
Rubber
washer
Non-dropping
screw
FIG.18
KDP1 360 FP
Presence detector
Refer to wiring diagrams for correct
wire connection (See FIG.5 - FIG.7).
There is a "∆"symbol on the side of
the surface of junction box KDP1, the
housing of KDP1 and the decorative
frame respectively for position
verified convenience. Keep the ∆
symbol on the junction box KDP1
and detectors front cover in line to
assemble them with the attached 4
non-dropping screws, then cover up
the decorative frame of detector (See
FIG.19) and turn it to be tight.
FIG.19
Restore power supply.
Instructions manual | 33