Fellowes Cambio Manual Del Usuario página 3

INSTALLATION OF BASE
STEP 1
Attaching side brackets
• Place table face down on a soft, clean surface.
• Unpack the crossbar and carefully place it on the floor.
• Attach the side bracket to the end of the crossbar.
• Repeat the same process to assemble the other side bracket.
*Note: Make sure the crossbar and side brackets remain facing up
during installation.
STEP 2
Adjust the position of the frame before attaching it to the table
Adjust the cross channels to their final lengths.
•
• Use the 5mm Hex key to loosen the (8) set screws on the inward
side of the cross channels.
• Check that the top supports on each side are aligned with the
pre-drilled holes on frame.
• Once properly adjusted, use the 5mm Hex key to re-tighten the
set screws (8 total).
B
A
O
O
3