PROPAIN 000871-AD Instrucciones De Montaje página 11

// INFLATING THE TIRE
If you have ordered your bike without tubeless setup, inflate the tires to a pressure of about 2 bar.
If you have ordered your bike with tubeless setup, you must fill both tires with the enclosed sealing fluid before the first ride.
1
1. Release the air from the tire completely.
2. Unscrew the valve cap.
3. Unscrew the valve insert from the valve using the valve
key supplied.
2
1. Shake the provided sealing fluid for about one minute.
2. Fill the sealing fluid through the valve into the tire.
Approximately 60 ml of sealing fluid should be used
per tire.
3. Screw the valve insert into the valve using the valve key
and tighten it by hand.
3
1. Inflate the tire to about 2 bar.
2. Check the correct fit of the tire.
→ The tire must contact the rim evenly around its
entire circumference. If not, release the air, press
the tire into the center of the rim bed and repeat
the procedure.
→ Have the tire seat checked by a professional if in
any doubt.
3. Slowly rotate and shake the wheel to distribute the
sealing fluid over the entire inner surface of the tire.
4. After the tire bead is fully seated, reduce the pressure to
your own requirements.
5. Screw on the valve cap.
6. Carry out a short test ride and check the tire pressure
regularly.