Function Of Air-To-Water Unit - Panasonic S-80MW1E5 Instrucciones De Operación

Function of Air-to-Water Unit

20:30 (THU)
Menu 20:30 (THU)
1. Basic instructions
2. FLAP
3. Lock indiv. flap
4. ON/OFF timer
[ ] START
Sel. Page [ ] Confirm
Menu
11. Initial settings
12. Ventilation
13. Setting list
14. Air-to-Water unit
Sel. Page [
TANK mode
„ Sterilization timer
To prevent propagation of legionella bacterium in the tank, it is able to perform sterilization process once a week.
While the sterilization process is performed,
● Timer Setting
Air-to-Water unit
Sterilization timer
Stop sterilization
Int.heater forced ON
Sel. /
Air-to-Water unit
Start day and time
SUN
Change Hour
● Under Sterilization process
Target water out temperature for sterilization (If
the set temperature is higher than temperature for
sterilization, the set temperature is displayed.)
„ Stop sterilization
Under unavoidable circumstances, this function is enabled when
the Air-to-Water unit must be stopped. The display on the right
appears.
10
1 Display the menu screen.
2 Select
20:30 (THU)
[14. Air-to-Water unit].
] Confirm
If "Sterilization timer" is enabled
20:30 (THU)
of the week and time for sterilization process.
[ ] Set
Set the day of the week and time for sterilization process.
20:30 (THU)
Select the item by
0 : 00
HOT-WATER-SUPPLY
Under Sterilization
* It takes a maximum of 4 hours to finish the sterilization process.
* It is recommended to set the time not to overlap with other timer such as weekly timer.
* In the centralized controller, the set temperature of normal operation is displayed even during
 TANK mode
Air-to-Water unit
Sterilization timer
Stop sterilization
Int.heater forced ON
Sel.
 Air-Conditioning mode
Air-to-Water unit
Int.heater ON/OFF
Heating curve range
→
Int.heater forced ON
Sel.
icon appears.
20:30 (THU)
SET TEMP.
TANK
Sterilizing
[ ] Close
℃
Caution: Be careful. Hot water may lead to a burn injury.
sterilization.
Although it is able to change the set temperature or turn ON/OFF by the centralized
controller, sterilization process will continue.
If the Air-to-Water unit is stopped by the centralized controller during sterilization process, the
Air-to-Water unit will be stopped after sterilization process.
3 Select the item
20:30 (THU)
/ [ ] Set
20:30 (THU)
/
, the screen is switched to set the day
button and decide by
Under sterilization, the set temperature
*
cannot be changed.
Air-to-Water unit
Sterilization timer
Stop sterilization?
Stop sterilization
Int. heater forced ON
YES NO
Sel. [ ] Set
to set.
→
button.
20:30 (THU)