NOCCHI SENSORMAT Manual De Uso página 32

GB
- Line n. 2 MIN0X.XS
+
With keys (16)
(normally 0). Confirm by pressing key (18)
units involved. With keys (16)
assigned to the third pump.
ENTER
Press key (18)
case of this example it is for 4.4 BARs - normally 0.5 to 1.0 lower than maximum pressure). The following message
will be displayed:
PRES. Bar PO:4
MAX04.6 MIN04.1
- Line n. 1 PRESS. BAR PO: 4
Indicates the number of pumps to which the pressure values of the following line refer to
- Line n. 2 MAX0X.XS
+
With keys (16)
(normally 0). Confirm by pressing key (18)
units involved. With keys (16)
assigned to the pump which is started fourth.
ENTER
Press key (18)
of this example it is for 4.6 BARs (normally 0.3 to 1.0 lower than the value assigned to pump 3).
- Line n. 2 MIN0X.XS
+
With keys (16)
(normally 0). Confirm by pressing key (18)
of units involved. With keys (16)
assigned to the fourth pump (in the case of this example its for 4.1 Bars - normally from 0.5 to 1.0 lower than maximum
pressure).
ENTER
Press key (18)
case of this example it is for 4.1 BARs (normally 0.5 to 1.0 lower than the maximum pressure).
Naturally if the unit is comprised of a lower number of pumps, for instance 3 pumps, and the relative menu has
been configured, it is not required to enter values regarding a fourth pump.
The pilot pump is associated with maximum and minimum pressure values assigned to pump. 1.
Units with air compressor command
If the unit is equipped with compressor for the maintenance of air cushion in the autoclave tank, the menu, after entering
maximum and minimum values for pressure assigned to the last pump, will ask for the pressure values to attribute
to the air compressor. The following message will be displayed:
COMPRESSOR
MAX05.8 MIN05.3
- Line n. 1 COMPRESSOR
Not modifiable
30
-
or (17) et the number in tens of minimum pressure value for the third pump
ENTER
+
or (17)
and set the pressure decimal value always confirming with key (18)
-
or (17) set the number in tens of maximum pressure value for the fourt pump
ENTER
+
or (17)
and set the pressure decimal value always confirming with key (18)
-
or (17) set the number in tens of minimum pressure value of the fourth pump
ENTER
+
or (17)
and set the pressure decimal value always confirming with key (18)
. The cursor will change position depending on the number of
-
set the number of maximum pressure units (in BARs)
. The cursor will change position depending on the number of
-
set the number of minimum pressure units (in BARs)
. The cursor will change position depending on the number
-
set the number of minimum pressure units (in BARs)
ENTER (in the
ENTER
In the case
ENTER
(in the