Interior Light; Shelf Instructions - Char-Broil 463641419 Guía De Producto

• The range of the temperature control is from 34 °F to 43°F.
• To view the set temperature at any time, touch the UP or
DOWN symbol. The set temperature will flash in the display
window for 5 seconds. After 5 seconds, the temperature inside
the unit will reappear in blue in the display window.
• If the unit is unplugged, or power is lost or turned off, you
must wait 3 to 5 minutes before restarting the unit. If you at-
tempt to restart before this time delay, the unit will not start.
• When you use the unit for the first time or restart the unit
after it has been shut off for a long time, there could be a few
degrees variance between the temperature you select and
the one indicated on the LED readout. This is normal and is
due to the length of the activation time. There should not be a
problem once the unit has been running for a few hours.

Interior Light

• The unit is equipped with an interior LED light which can be
turned ON or OFF by touching the
Door Lock
• Your unit is provided with a lock and key combination.
• The keys are located inside the plastic bag that contains
the Owner's Manual. Insert the key into the lock and turn it
counterclockwise to unlock the door. To lock the door, do
the reverse operation, making sure the metal pin is engaged
completely. Remove the key and put it in a secure place for
safekeeping.
Shelves
• To prevent damaging the door gasket, make sure to have the
door all the way open when pulling the shelves out of the rail
compartment.
• For easy access to the stored content, you can pull the shelf
approximately halfway out of the rail compartment. However
this unit was designed with a plastic post on each side of the
shelf track to prevent shelf contents from falling.
• When removing the shelf from the inner rails, make sure to
remove all shelf contents first. Then move the shelf to the
position where the notches in the shelf are exactly aligned
with the plastic posts and lift the shelf. In order to replace the
shelf, repeat this procedure in reverse.
Defrosting
• Your Refrigerator is designed with "Auto-cycle" defrost
system. During the "Off-cycle," the refrigerated surfaces of
the Refrigerator defrost automatically. Defrost water from
the Refrigerator storage compartment drains automatically
and part of it goes into a drainage container, which is located
at the back of the Refrigerator above the compressor. The
heat is transferred from the compressor and evaporates
any condensation that has collected in the pan. Part of the
remaining water is collected within the Refrigerator for
humidity purposes.
Operating Noise
• To reach the desired temperature settings, the Refrigerator
symbol.
4
C A U T I O N
• Do not overfill the Refrigerator as this may prevent air
circulation.
• Do not open the door unless necessary.
• Do not cover shelves with aluminum foil or any other
shelf material which may prevent air circulation.
• Clean the Refrigerator before storing for long periods
of Time. Leave the Refrigerator door ajar to allow air
to circulate inside, and to avoid possible formation of
condensation, mold or odors.
operates with compressors and fans, and may produce the
following types of noises. These noises are normal and may
occur as follows:
• Gurgling sound - caused by the refrigerant flowing
through the appliance's coils.
• Cracking/popping sounds - resulting from the con-
traction and expansion of the refrigerant gas to cool the
appliance.
• Fan operating sound - to circulate the air within the
Refrigerator.

Shelf Instructions

• Do not cover shelves with aluminum foil or any other
material as this will impede air flow inside the cabinet and
can adversely affect the interior cabinet temperature.
• To remove a shelf, tilt one side up and pull the shelf
outward.
• To replace a shelf, ensure the shelf is resting securely on
the support brackets and push inward until it locks into
place.
Cleaning Your Refrigerator
• Turn off the power, unplug the appliance, and remove all
items including the shelves.
• Wash the inside surfaces with a warm water and baking
soda solution. The solution should be about 2 tablespoons
of baking soda to a quart of water.
• Wash the shelves with a mild detergent solution.
• Wring excess water out of the sponge or cloth when
cleaning area of the controls, or any electrical parts.
• Wash the exterior cabinet with warm water and mild liquid
detergent. Rinse well and wipe dry with a clean soft cloth.
Power Failure
• Most power failures are corrected within a few hours and
should not affect the temperature of your appliance if you
minimize the number of times the door is opened. If the
power is going to be off for a longer period of time, you
need to take the proper steps to protect your contents.
Vacation Time
• Short vacations: Leave the Refrigerator operating during
vacations of less than three weeks.