Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Grounded Outlet
Ungrounded Outlet with Adaptor
The power cable must be plugged into an
•
appropriate outlet that is nearby, properly
installed, and grounded in accordance with
all local codes and ordinances.The unit is for
use on a nominal 120V circuit and should be
connected to a grounded outlet. A temporary
adaptor, always being held in place by a screw,
may be used to connect this plug to a 2-pole
outlet if a properly grounded outlet is not
available. The adaptor should be used only until
a properly grounded outlet can be installed by a
qualified electrician. The green colored rigid ear,
lug, and the like, extending from the adaptor
must be connected to a permanent ground such
as a properly grounded outlet box cover.
•
An extension cord must have adequate
wire size (AWG or American Wire Gauge)
for safety. The smaller the gauge number of
the wire, the greater the capacity of the cable.
For example, a 16 gauge wire has more capacity
than an 18 gauge wire. An undersized cord will
cause a drop in line voltage resulting in loss of
power and overheating. When using more than
one extension to make up the total length, be
sure each individual extension contains at least
the minimum wire size. The following table
shows the correct size to use depending on
cord length and nameplate ampere rating. If in
doubt, use the next heavier gauge. The lower the
gauge number, the heavier the cord. A proper
extension cord will be marked with the suffix
letter 'W' and with a tag stating 'Suitable for Use
with Outdoor Appliances.
Minimum gauge for Cord sets
Volts
Total length of Cord in Ft. (m)
120 V
25 (7.6) 50 (15.2) 100 (30.5) 150 (45.7)
240 V
50 (15.2) 100 (30.5) 200 (61.0) 300 (91.4)
Ampere
Rating
More
not
American Wire gauge
Than
More
Than
0
6
18
6
10
18
10
12
16
12
16
14
16
16
14
16
14
12
16
14
12
12
Not Recommended
sAVE ThEsE insTRUCTiOns FOR
FUTURE UsE
Service & Repairs
The unit is not serviceable by the user.
WARNING: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment should be performed by a
D
WALT factory service center or a D
e
authorized service center. Always use
identical replacement parts.
Cleaning
ALWAYS unplug the unit when cleaning.
WARNING: Blow dirt and dust out of all air
vents with clean, dry air at least once a week.
To minimize the risk of eye injury, always
wear ANSI Z87.1 approved eye protection
when performing this.
WARNING: Never use solvents or other
harsh chemicals for cleaning the non-
metallic parts of the product. These
chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened
only with water and mild soap. Never let any
liquid get inside the product; never immerse
any part of the product into a liquid.
One Year Limited Warranty
D
WALT will repair, without charge, any defects
e
due to faulty materials or workmanship for one
year from the date of purchase. This warranty
does not cover part failure due to normal wear or
abuse. For further detail of warranty coverage and
warranty repair information, visit www.D
com or call 1-800-4-D
WALT (1-800-433-9258).
e
This warranty does not apply to accessories or
damage caused where repairs have been made
or attempted by others. THIS LIMITED WARRANTY
IS GIVEN IN LIEU OF ALL OTHERS, INCLUDING
THE IMPLIED WARRANTY OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE, AND
EXCLUDES ALL INCIDENTAL OR CONSEQUENTIAL
DAMAGES. Some states do not allow limitations
on how long an implied warranty lasts or
the exclusion or limitation of incidental or
consequential damages, so these limitations may
not apply to you. This warranty gives you specific
English
WALT
e
WALT.
e
7
Publicidad
Tabla de contenido
