Important - Textron Ransomes Mastiff 91 FN Serie Manual De Seguridad, Funcionamiento Y Mantenimiento

7 OPERATION
7.5 STARTING THE ENGINE
1. Electric Start
Apply the brake.Turn starter switch
(C) clockwise to the first position,
then turn further clockwise to the start
position and engine will start. If
engine fails to start within 10
seconds, wait a further 30 seconds
before attempting to start the engine
again.
NOTE: The starter switch will automatically return
to the run position from the start position when
released.
DO NOT turn switch to the off position as this will
stop the engine. The switch acts as a cut out
switch.
2. Recoil Starter (D)
(a) Pull the recoil starter handle (D)
slowly until
resistance can be felt on
compression, continue to pull until
the resistance ceases.
(b) Allow the rope to recoil slowly then
pull handle sharply, the engine will
then start. Failure to do this may
result in the rope being broken if a
backfire occurs.
IMPORTANT: The starter rope should never be
allowed to recoil sharply into its housing. The
rope should recoil slowly under control to avoid
breakage or damage.
Broken starter ropes should be replaced - NOT
REPAIRED.
GB-26
SAFETY, OPERATORS & MAINTENANCE MANUAL
Copyright Briggs & Stratton Corp. Used with Permission.
B
A
C