Bissell POWERTRAK POWERFORCE 31L9 Serie Guia Del Usuario página 14

M
aintenance and care
Cleaning the pre-motor filter
The pre-motor filter protects the motor from dirt and
dust particles. Use only BISSELL replacement filters.
1.
Turn the power OFF. Unplug the vacuum
from the electrical outlet.
2.
Remove the dirt container from the vacuum.
3.
The pre-motor filter is located behind the
door labeled "FILTER" on the main body of
the vacuum. Open the door by pushing up
on the tab at the bottom of the door and
pulling out to remove.
4.
Remove the filter tray by pulling up on the
tab of the tray. Remove the pre-motor filter
and set aside. Tap the tray gently over a
trash can to remove any dirt or debris.
5.
The pre-motor filter can be washed in cold
water with a mild detergent. Rinse well and
air dry thoroughly before placing back into
the tray.
6.
Place the tray back into the vacuum and
replace the filter door by inserting the tabs
at the top of the door and pushing down
until it clicks into the locked position.
12
w w w . b i s s e l l . c a
w w w . b i s s e l l . c a
NOTICE:
This product is intended for household
use only and not for commercial or
industrial use. Vacuuming of dust from
products like plaster, concrete or ashes
will damage the motor and void the
warranty.
3.
Pre-Motor Filter
4.
Tip:
For maximum cleaning
performance, check the
filters often and clean or
replace if necessary.
WARNING:
Do not operate cleaner with
damp or wet filters or without
all filters in place.
8 0 0 . 2 6 3 . 2 5 3 5
1 - 8 0 0 . 2 6 3 . 2 5 3 5
Filter Tray
11