Getting Started - ElektroStator T270 Manual De Instrucciones

GETTING STARTED

Baby unit power supply
Parent unit power supply
Using the baby monitor
Setting up
- Place the baby unit in a convenient location (e.g. on a table) and point the camera lens towards the area you
want to monitor. Adjust the baby unit until you are satisfied with the image in the parent unit.
- To mount the baby unit on the wall, see section „Wall mounting instructions" for more
details.
NOTE: do not place the baby unit within baby's reach! If there is interference on the picture or sound, try
moving the units to different locations, and ensure they are not close to other electrical equipment.
Pairing camera
The enclosed baby unit has already been registered, you do not need to register it again
unless the baby unit loses its link withe parent unit. See section „Camera registration"
for more details.
Night vision
The baby unit has 9 high-intensity infrared LEDs for picking up clear images in the
dark.
Music player
Press and hold music key at least 3 seconds will turn on the music player and play
lullaby through the baby unit; long press the key 3 seconds again will turn off it.
1. Connect the small plug of the power adapter to the baby unit and the
other end to the
mains socket. NOTE: only use the power adapter provided.
2. A green light LED will display indicate the baby unit is working.
Charging the power unit fully before use is recommended.
This will allow the unit to operate on battery in the event of a power
failure.
1. Connect the plug of the adapter to the parent unit and the other end
to the mains
socket. NOTE: only use the power adapter provided.
2. The LCD screen illuminates and starts up automatically after a few
seconds.
3. Press and hold power key at least 3 seconds to turn on the parent
unit.