Double DIN head unit provisions
3. Mount the (2) panel clip legs to the
radio trim panel with the provided
(4) #4 Phillips screws. Attach the
(2) panel clips to the legs.
(Figure B)
Clip leg locations
(Figure B)
Kit Assembly
4. Locate the factory wiring harness
and antenna plug in the dash.
Refer to the wiring section of
this manual.
5. Mount the new aftermarket radio
assembly into the dash and
reassemble dash in reverse order
of disassembly.
99-7803G
ISO DIN head unit provisions
1. Mount the pocket to the radio
brackets with four of the supplied
#8 x 3/8" Phillips screws. (Figure A)
(Figure A)
4
2. Mount the radio brackets to the
radio trim panel with four of the
supplied #8 screws. (Figure A)
Continued on next page
Step 1.
Step 2