Operating Mode - Desoutter ERAL Serie Manual Del Usuario

6159935760
Issue no: 13
Series: -
Original instructions.
© Copyright 2019, Ets Georges Renault
44818 St Herblain, FR
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
DECLARATION OF USE
Tool (class I, IP40) suitable for industrial
environment only. It shall be used for tightening
or loosening joints in wood, metal or plastic
material. No other use will be permitted. For
professional use only.
DATA
(See page 4).
Noise level: < 70 dB(A) (EN 60 745).
Vibration level: < 2.5 m/s² (EN 60 745).
Declaration of noise and vibration emission
All values are current as of the date of this
publication. For the latest information please visit
desouttertools.com.
These declared values were obtained by
laboratory type testing in accordance with the
stated standards and are suitable for comparison
with the declared values of other tools tested
in accordance with the same standards. These
declared values are not adequate for use in risk
assessments and values measured in individual
work places may be higher. The actual exposure
values and risk of harm experienced by an
individual user are unique and depend upon
the way the user works, the workpiece and the
workstation design, as well upon the exposure
time and the physical condition of the user.
We, Desoutter, cannot be held liable for the
consequences of using the declared values,
instead of values reflecting the actual exposure,
in an individual risk assessment in a work place
situation over which we have no control.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
An EU guide to managing hand-arm vibration
can be found at http://www.pneurop.eu/uploads/
documents/pdf/PN3-02-NV_Declaration_info_
sheet_0111.pdf
We recommend a programme of health
surveillance to detect early symptoms which
may relate to noise or vibration exposure, so
that management procedures can be modified to
8 / 60
help prevent future impairment.
REQUIREMENTS
These tools need to be use with controllers from
Desoutter range.

OPERATING MODE

This tool will only work with firmware
release 4.4E and above.
Fit the tool with a suitable fastening accessory,
then connect it to the power supply by means of
the controller.
Select the appropriate program on the controller.
Hold the tool by means of the handle and apply
to the fastener to be tightened.
In manual mode, the motor will start only when
the trigger is operated.
For a reverse rotation, press the reverse button
and apply the tool to the fastener.
As the reaction force increases in proportion to
the tightening torque, make sure that the tool
is in perfect working order and the controller
is programmed correctly, to reduce the risk of
injury to the operator as a result of unexpected
behaviour of the tool.
TOOL CLAMPING AREA
Angle head nut runners
When handled by an operator or embedded on a
robot with high dynamics, it is advised to select
two clamping locations instead of one (see
"Figure A", page 5).
Safe clamping locations.
Preferred clamping area.
Other clamping area where extra
clamping force and stress (due do torque
reaction or extra stress from the operator
in use) can lower performance and
liability.
To select as secondary clamping area or
as last option with extra care.
In-line nut runners
When handled by an operator or embedded on a
robot with high dynamics, it is advised to select
two clamping locations instead of one (see
"Figure B", page 5).
Dedicated clamping area for torque
reaction.
Preferred clamping area.
01/2019