Electrical Installation - Calorex PRO 40 L Manual De Instalación Mantenimiento Y Operación

20 / EN

ELECTRICAL INSTALLATION

Follow the numbered steps below for a correct installation:
1. Check that the voltage is appropriate for this appliance; you can verify this information
on the product data label (placed on one side of the heater).
2. Install the water heater as close as possible to the electric current (charging center), with
the voltage that will be used, which must be accessible and must include a switch break
or QO breaker.
3. As a safety measure it is obligatory to install a 30 Amp thermo-magnetic circuit breaker
independently of the main line, for automatic deactivation in the case of an electrical
fault or imbalance.
4. Extend or lead the independent cables from the power supply through a conduit tube
or polyduct to the heater.
5. Use No. 14 caliber THW cable for the connections, which must be made with a interlace
cable tie. We recommend using the colors used in the water heater wiring.
6. Ensure and verify that the green physical ground wire is correctly connected to the
terminal at the charging center.
7. Insulate or tape the moorings with non-inflammable plastic insulating tape.
8. Fill the heater with water to allow the air to exit. Open a hot water service, until water
comes out the service line.
Ground
Neutral (N)
Line (L)
Thermostat
Swith
Pilot lamp
Heating Element