Programming Tv/Vcr Combo Control - Universal Electronics ATLAS Guia Del Usuario

Atlas Manual rev2 E/Sp

PROGRAMMING TV/VCR COMBO CONTROL

If you own a TV/VCR Combo, perform the following
instructions to control this device:
1. Turn on your TV/VCR Combo and insert a
video cassette.
2. On the remote control, press VCR once.
Press and hold SETUP until the VCR key
blinks twice, then release SETUP.
3. Use the Setup Codes For TV/VCR Combos (on
page 48) to locate the brand name and then
enter the first four-digit code for your TV/VCR
Combo. If you perform this procedure correctly,
the VCR key will blink twice.
NOTE: If the VCR key did not blink twice after enter-
ing the code's last digit, then repeat steps 2 to 3 and
try entering the same code again.
If you've located a TV/VCR setup code that
works your TV/VCR Combo and a separate TV
code is also listed, you'll need to program this
code into the remote control to access volume
control (see Programming Device Control on
page 8).
4. Aim the remote control at your TV/VCR
Combo and press POWER once. The device
should turn off. If it does not respond, repeat
steps 2 and 3 (starting on the previous page),
trying each code listed for your brand until you
find one that works. If it still does not work, try
searching for the code (see Searching For Your
Code on the next page).
5. For future reference, write down each working
device code in the boxes below:
TV/VCR
TV (if used)
5/8/03 5:18 PM Page 10
10