Using The Master Power Key; To Program The Master Power Key; To Clear The Master Power Key; To Operate The Master Power Key - Universal Electronics ATLAS Guia Del Usuario

Atlas Manual rev2 E/Sp

USING THE MASTER POWER KEY

The Atlas Universal Remote Control has a unique feature
that allows you to sequentially turn on or off all of your
home entertainment devices with a single key press.
NOTE: MASTER POWER only works in the CBL mode. If it is not
programmed, only the cable converter will turn on or off. In any
other mode, pressing MASTER POWER once will turn on or off the
selected device.

To Program The Master Power Key:

1. On the remote control, press and hold SETUP
until the last-selected device key blinks twice,
then release SETUP.
2. Enter 9 - 9 - 5. The last-selected device key will
blink twice. Then press POWER once.
3. For the first device you want in the power on
sequence, press a device key (e.g., CBL) once
and then press POWER once.
4. Repeat step 3 up to three more times to add the
second, third, and fourth device, as desired.
5. To save the settings and exit the program, press
CBL once. Next, press and hold SETUP until the
CBL key blinks twice, then release SETUP.

To Clear The Master Power Key:

1. Perform steps 1 and 2 in the above section.
2. To clear the settings and exit the program, press
and hold SETUP until the CBL key blinks twice,
then release SETUP.

To Operate The Master Power Key:

1. After programming, point the remote control
at the devices. Press CBL once.
2. Press MASTER POWER once to sequentially turn
on or off all home entertainment devices.
3. You will see the devices turn on or off
according to the programmed sequence.
5/8/03 5:18 PM Page 15
15